SMC Networks EXW1-BENAC1 Operation Manual page 117

- Wireless Base unit (EX600-WPN#) setting parameters
Classification Parameter name
HOLD/CLR
a)
(unit)
b) Input size
Output size
c) (includes
valves)
Base setting in which
includes a
d)
valve density
of
Wireless
e)
signal
Unit address
f)
order
a) I/O mapping
System input
b)
size
System
c)
output size
System
setting Diagnostic
d)
allocation
Max. Remote
e)
units
DA refresh
f)
time (sec)
a) Pairing
Remote
registration
Remote
b)
registration
Dummy
c)
Remote
Set value
CLEAR / HOLD / Software
Control
0 to 128 points (0 to 16
bytes)
Increase and decrease by
16 points (2 bytes).
0 to 128 points (0 to 16
bytes)
Increase and decrease by
16 points (2 bytes).
0 to 32 points (0 to 4 bytes)
Increase and decrease by 8
points (1 byte).
Active / Idle
Mode 1 / Mode 2
Auto
-
-
None / Simple / Advanced
0 / 15 / 31 Remotes
0.1 / 0.2 / 0.5 / 1 / 2 / 5 / 10 /
30 / 60 s
Normal / pairing modes
Allocation and registration of
the Wireless Remote unit to
the wireless channel.
Addition of dummy Remote
to the wireless channel
-116-
Setting
Initial value when
power is off
CLEAR Available
128 points /
Available
16 byte
128 points /
Available
16 byte
32 points /
Available
4 byte
Active Available
Mode 1 Available
Auto Available
- -
- -
Advanced Available
15 Remotes Available
1 s Available
Normal mode Available
Remote not Not
registered available
Dummy Remote Not
unset available
Note
Setting the output operation when
the fieldbus communication is
disconnected.
The valve manifold output points are
included in the module output points.
The number of effective points are
limited to within the setting range of
the module output points.
If set to "Idle", the wireless
communication is disconnected.
Mode 1:
Allocation to the right from the end
plate.
Mode 2:
Allocation to the left from the
wireless unit.
For PROFINET Wireless Base I/O,
only automatic mapping is available.
This is not settable when the I/O
mapping is set to "Auto".
This is not settable when the I/O
mapping is set to "Auto".
Diagnostic information is allocated to
the head of the input data of the I/O
map.
Wireless channels for the number of
the set units are enabled.
Set the sampling frequency of the
analog output equipment.
Normal mode:
Wireless Remote cannot be
registered.
(Communication with the registered
Remote will be established).
Pairing mode:
Wireless Remote can be registered.
Refer to dummy Remote registration
for setting details .
No.EX##-OMV0017-G