Accessing Your Matrox Iris E-Series Using Telnet; File Transfer Protocol (Ftp) - Matrox Iris E Series Installation And Technical Reference

C h a p t e r 5 : A c c e s s i n g M a t r o x I r i s E - S e r i e s
• Open a command prompt (DOS box) and type the following at the command
• Open Microsoft Internet Explorer and go to the following address:
❖ Note that if authentication (either basic or NTLM) is enabled, you will be
• Open a command prompt and type the following:
A c c e s s i n g y o u r M a t r o x I r i s E - S e r i e s u s i n g t e l n e t
To access Matrox Iris E-Series using a telnet application, perform one of the
following:
prompt:
telnet IrisName
telnet://IrisName
You can enable or disable your Matrox Iris E-Series telnet server through the Telnet
/ FTP server settings page of the Matrox Iris portal website. If enabled, you can
also enable authentication from the same page.
prompted for a user name and a password. For more information, refer to the
Telnet/FTP servers and serial console settings page in the Administration utility
section of the Matrox Iris portal website.
F i l e t r a n s f e r p r o t o c o l ( F T P )
Each Matrox Iris E-Series has an FTP server. Through an FTP session, you can
transfer files to/from the flash disk to/from any drive mounted on your computer.
Logging of all FTP server activity is saved in a temporary file in the root folder of
Matrox Iris E-Series. You can access your Matrox Iris E-Series using an FTP
application that accesses the FTP server on Matrox Iris E-Series.
To access Matrox Iris E-Series using an FTP application, perform one of the
following:
ftp IrisName