Table of Contents
Advertisement
C h a p t e r 1 : B e f o r e y o u b e g i n
1. Unpack your Matrox Iris E-Series smart camera, verifying all parts are present.
2. Install Matrox Design Assistant on your computer, as described in Chapter 2:
3. Complete the hardware setup, as described in Chapter 3: Connecting to your Matrox
4. If your network does not rely on DHCP, you must connect to your Matrox Iris
5. Configure Internet Explorer to work with the Matrox Iris portal website, as
6. Go to the Matrox Iris portal website. Review and accept the license agreement.
7. Go the View utility web page. View an image from your smart camera, as described
8. Adjust the smart camera's focus and aperture manually.
9. Run Matrox Design Assistant and connect to your smart camera.
O v e r v i e w
The installation procedure consists of the following steps:
Refer to Inspecting your Matrox Iris E-Series package section, in Chapter 1: Before
you begin for more information.
Installing Matrox Design Assistant.
Iris E-Series.
E-Series and change its IP address, as described in Chapter 4: Your Matrox Iris
E-Series without DHCP.
described in Matrox Iris portal website section, in Chapter 3: Connecting to your
Matrox Iris E-Series.
in View images from your Matrox Iris E-Series section, in Chapter 5: Accessing Matrox
Iris E-Series.
You can then start using Matrox Design Assistant to browse the tutorials and
examples, start a new project, or open an existing project.
Advertisement
Table of Contents
