Handling And Installation; Recommendations For Handling And Installation; Packaging And Unpacking; Transport - Angelo Po 0N0BM1E User Manual

HANDLING AND INSTALLATION

RECOMMENDATIONS FOR HANDLING AND INSTALLATION

NOTE: Read the following sections
carefully before performing any handling
and installation operations:
– Hazards and safety provisions during trans-
port.
– Hazards and safety provisions during assem-
bly.
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement.
The packaging is designed to reduce space and
as appropriate to the type of transport used.To
simplify transport, some components may be
removed and suitably protected and packed
for transport.
The packaging carries all information necessary
for loading and unloading.
When unpacking, check that all components
are present in the correct quantities and are un-
damaged.
The packaging material must be properly di-
sposed of in accordance with legal require-
ments.
Diff erent means of transport may be used, also
depending on the destination.
The chart shows the most commonly used al-
ternatives.
During transport, securely fi x the packaging to
the means of transport to prevent undesirable
shifting.
8
tion operations shall be carried out in accor-
dance with current legislation on health and
safety at work.
If necessary, the person authorised to car-
ry out these operations should organise a
"safety plan" to protect the people directly
involved.
(water, electricity and gas) must be set up
exclusively by suitably qualifi ed staff , in ac-
cordance with local requirements.

PACKAGING AND UNPACKING

TRANSPORT

HANDLING AND INSTALLATION
WARNING: All handling and installa-
WARNING: The required connections
Means of transport
Lifting equipment
3319950_inst_GB_rev.3