Setting Serial Port Baud Rate; Enabling Serial Port Echo; Setting The Projector Address; Adjusting The Back Light Settings - Christie GS 2K Series User Manual

• Reset to Default—Resets the network configuration setting, including LAN setting and
WLAN setting, to default.
3. To apply the network configuration, press ENTER.

Setting serial port baud rate

Select the serial port and baud rate.
1. Select Menu > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, press ENTER.

Enabling serial port echo

Enable or disable to allow the CLI command pass through.
1. Select Menu > Configuration > Communications > Serial Port Echo.
2. To swap, press ENTER.

Setting the projector address

Assign an address to the projector for IR remote connection.
1. To set the projector address, select Menu > Configuration > Communications > Projector
Address.
2. Select specific number for this projector from 0 to 9. The projector responds to the IR remote
set to the same address as the projector or to the IR remote set to address 0.
3. To match up with the projector address, press PROJ and specific number key.

Adjusting the back light settings

Control the back light behavior and timeout setting for the keypad and status LED.
1. Select Menu > Configuration > Backlight Preferences > Keypad Backlight.
2. Select the appropriate setting for keypad backlight.
3. To confirm the selection, press ENTER.
4. Select Menu > Configuration > Backlight Preferences > Status LED.
5. Select the appropriate setting for status LED.
6. To confirm the selection, press ENTER.
GS Series 2K User Manual - DWU880-GS, DWU880A-GS, DWU9200-GS, DWU1100-GS, DWU1100A-GS
020-001908-01 Rev. 1 (02-2022)
Copyright © 2022 Christie Digital Systems USA Inc. All rights reserved.
Configuring communications
57