Enabling basic image blending
Configure blends directly on the projector to increase or decrease the borders of an individual
image, so it blends with a neighboring image to create a single, seamless image.
You can set blends on a projector when not using Christie Twist and Mystique. Connecting to Twist
and Mystique grays out the blend settings on the projector. Applying blends from Twist and
Mystique overwrites the blends directly set on the projectors.
1. Select Menu > Size & Position > Geometry Correction > Blend Area.
2. Choose a side to blend in with the other projectors.
3. To set up the starting position, select Start Pixel.
4. Adjust the slider by arrow keys or select ENTER to input the starting position.
5. After inputting the starting position, select ENTER.
6. To set up the size of blend area, select Pixel Height.
7. Adjust the slider by arrow keys or select ENTER to input the width of blend area.
8. After inputting the size of blend area, select ENTER.
9. To set the gamma value of the blend area, select Blend Gamma.
10. After selecting a gamma value, select ENTER.
11. To apply the settings, select Enable.
12. Select ENTER.
13. To save the blend setting, select Menu > Size & Position > Geometry Correction > Blend
Memory > Save Blend.
14. To set up the other side of blend area, repeat step 2 to 13.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the size and position
29