Download Print this page

Christie IMB-S2 Replacement Manual

Compactflash card replacement

Advertisement

Quick Links

Applies to the Following Products
Solaria One
Solaria One
Christie IMB-S2
This document provides information and procedures for replacing the SanDisk CompactFlash (CF) card
with an Advantech CF card on the Christie IMB-S2.
The existing SanDisk CF card in the Christie IMB-S2 can fail when the maximum read-modify-write
cycles are reached. A failed CF card can disrupt playback or make the Christie IMB-S2 unresponsive.
The number of replacement CF cards provided by Christie Digital Systems will match the quantity of
Christie IMB-S2s.
SanDisk CF card replacement is MANDATORY on all Christie IMB-S2s manufactured before
Christie IMB-S2
Replacement Advantech CompactFlash (CF) card (003-004700-02)
Replacement anti-tamper label (Christie Solaria One and Christie Solaria One
Christie IMB-S2 CompactFlash Card Replacement
020-200260-01 Rev. 1 (11-2013)
+
December 2013.
ELECTRICAL SHOCK HAZARD! Always turn off, disconnect, and disengage all power
sources to the projector before servicing. Failure to comply results in death or
serious injury.
Only Christie accredited service technicians are permitted to open any enclosure
on the projector and only if the AC power has been fully disconnected. Failure to
comply could result in minor or moderate injury.
When removing or installing the Christie IMB, wear an anti-static wrist strap and
follow anti-static protocols. Failure to comply could result in equipment or property
damage.
Prepared For
Internal and External Operators and Service
Technicians
External Customers
Christie Field Application Engineers (FAE)
Christie Service Technicians
Christie Personnel
+
only)
1

Advertisement

loading

Summary of Contents for Christie IMB-S2

  • Page 1 The existing SanDisk CF card in the Christie IMB-S2 can fail when the maximum read-modify-write cycles are reached. A failed CF card can disrupt playback or make the Christie IMB-S2 unresponsive. The number of replacement CF cards provided by Christie Digital Systems will match the quantity of Christie IMB-S2s.
  • Page 2 4. Enter a name for the backup file. 5. Tap Enter. 6. Tap OK. This procedure describes the removal of a Christie IMB-S2 from a Christie Solaria One projector. For removal instructions that are specific to your projector model, see the projector Service Manual.
  • Page 3 5. Remove the card cage faceplate by the handles and set it on a stable surface. 1. On the underside of the Christie IMB-S2, pull the CF card retaining clip down and out of the way. 2. Pull the CF card (A) out of the housing and discard it following your local regulations for electronic waste disposal.
  • Page 4 7. Tap Restore. 8. Tap Yes. Upload and install the latest Christie IMB software so all of the Christie IMB software components are the same version. Contact Christie Technical Support to request the latest version of the Christie IMB software.
  • Page 5 1. Tap Menu > Christie IMB > System > Licenses. 2. Tap Add. 3. Insert a USB flash drive with the Christie IMB license into the USB port on the side of the touch panel controller (TPC). 4. Select a license file and then tap Accept.