Adjusting The Image With Automatic Focus; Adjusting Lens Position; Saving Lens Setting; Applying The Previous Lens Setting - Christie Inspire Series User Manual

7. To exit the menu, select EXIT.
8. To refine your adjusts, repeat steps 2 to 7.

Adjusting the image with automatic focus

Adjust the image focus automatically with camera kit.
• Auto focus option is disabled and grayed out if the picture mode is set to 3D or High Frame Rate
with the current source or change to no source status.
(The camera does not support 1x color wheel speed.)
• Auto focus option is also disabled and grayed out if the camera is not detected or lens lock option
is enabled.
1. Display an image or test pattern that can be used to analyze image focus.
2. Select Menu > Configuration > Lens Settings > Auto Focus.
3. Select ENTER.

Adjusting lens position

Shift the lens to the specific position.
1. Display an image or test pattern that can be used to analyze image location.
2. Select LENS on keypad or LENS H/LENS V on remote control.
You can also select Menu > Configuration > Lens Settings > Lens Shift.
3. Use the arrow keys to adjust the lens position.
4. To exit the menu, select EXIT.

Saving lens setting

Save the lens position, zoom and focus. One projector can save maximum up to five lens settings.
1. Select Menu > Configuration > Lens Settings > Lens Shift Memory > Save Current
Settings.
2. To save the lens setting, select an empty record.
3. To confirm the selection, select ENTER.

Applying the previous lens setting

Apply the previous lens setting.
1. Before applying the previous lens setting, you must save the lens setting.
See Saving lens setting
2. Select Menu > Configuration > Lens Settings > Lens Shift Memory > Apply Position.
3. To apply specific lens setting, select the required record.
4. To confirm the selection, select ENTER.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
on page 51 for more details.
Configuring system settings
51