Adjusting Wlan Setting; Adjusting Network Setting; Setting Serial Port Baud Rate; Enabling Serial Port Echo - Christie Inspire Series Installation And Setup Manual

Adjusting WLAN setting

Set up network configuration for wireless networking.
1. Select Menu > Configuration > Communications > WLAN.
2. Set up the appropriate setting:
• SSID—Display the SSID of the wireless network.
• Enable—Enable or disable the wireless functionality.
• Start IP—Assign the start IP address of the wireless network.
• End IP—Assign the end IP address of the wireless network.
• Subnet Mask—Assign the subnet mask of the wireless.
• Default Gateway—Assign the gateway of the wireless.
3. To apply the WLAN settings, select Apply.

Adjusting network setting

Set up network configuration setting, such as reset back to default.
1. Select Menu > Configuration > Communications > Network.
2. Set up the appropriate network setting:
• Projector Name—Display the name of the projector. User can change the name of the
projector by web user interface.
• Show Network Message—Enable or disable to display of the network message.
• Reset to Default—Reset the network configuration setting, including LAN setting and
• WLAN setting, back to default.
3. To apply the network configuration, press ENTER.

Setting serial port baud rate

Select the serial port and baud rate.
1. Select Menu > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, press ENTER.

Enabling serial port echo

Enable or disable to allow the CLI command pass through.
1. Select Menu > Configuration > Communications > Serial Port Echo.
2. To swap, press ENTER.
Inspire Series Installation and Setup Guide
020-001933-01 Rev. 1 (10-2021)
Copyright ©2021 Christie Digital Systems USA Inc. All rights reserved.
Configuring light settings
34