Fax Polling Security; Polling Security Setting; Passcode Number Setting - Xerox WorkCentre C226 System Administration Manual

NOTE:
Xerox WorkCentre C226 System Administration Guide

Fax polling security

These settings are for using the Public Box for polling memory. Note that they do not
apply to F-code polling memory.
The "Fax polling security" are as follows:
•

Polling security setting

•

Passcode number setting

• Set number of times public box may be polled
Polling security setting
When performing polling memory, this setting is used to select whether any machine
will be allowed to poll your machine, or only machines that have been programmed in
your machine. Polling security setting is normally turned on (a checkmark appears in
the box).
To allow any machine to poll your machine, touch the box to remove the checkmark.
If polling security setting is enabled, enter the numbers of the fax machines to be
allowed to poll your machine in "Passcode number setting" below.
Passcode number setting
When the polling security setting is turned on, use this setting to program (or delete)
the fax numbers of the machines that are allowed to poll your machine. Programmed
fax numbers are called passcodes. Up to 10 fax numbers can be programmed.
Programming passcode numbers
1. Touch the [ENTER] key.
The passcode entry screen appears.
Key Operator Programs
Passcode Number Setting
Enter
Ok
Delete
Key Operator Programs
6-61