Programming, Editing, And Deleting F-Code Memory Boxes; Programming An F-Code Memory Box - Xerox WorkCentre C226 System Administration Manual

Programming, Editing, and Deleting F-Code Memory Boxes

Programming an F-Code Memory Box

NOTES:
Xerox WorkCentre C226 System Administration Guide
The procedure for programming a memory box for F-code transmission is explained
here. There are three types of F-code memory boxes: F-code polling memory, F-code
confidential transmission, and F-code relay broadcast. Memory boxes are pro-
grammed, edited, and deleted as follows.
A box name, sub-address/passcode, and function must be programmed in a memory
box.
• When programming a new memory box, a sub-address that is being used for
another box cannot be used. The passcode, however, can be the same as a
passcode used in another box.
• A passcode can be omitted.
• Up to 50 F-code memory boxes can be programmed. If 50 F-code memory boxes
have already been programmed, a warning message will appear and you will not
be able to program a new box. First delete an unused F-code memory box
(page 6-37) and then program the new box.
1. Press the [CUSTOM SETTINGS] key and then touch the [ADDRESS CONTROL]
key (refer to steps 1 and 2 on page 6-9).
2. Touch the [F-CODE MEMORY BOX] key.
Custom Index
F-Code Memory Box
Programming, Editing, and Deleting F-Code Memory Boxes
6-29