Using The Key Operator Programs - Xerox WorkCentre C226 System Administration Manual

Using the Key Operator Programs

Xerox WorkCentre C226 System Administration Guide
The procedure for configuring the key operator programs is explained below using the
"Key operator code change" program as an example. Follow the same steps to config-
ure the programs that are explained beginning on page 6.
/
1. Press the [CUSTOM SETTINGS] key.
2. Touch the [KEY OPERATOR PROGRAMS] key.
Address
Receive Mode
Control
Key Operator Programs
3. Use the numeric keys to enter the five-digit key operator code.
Key Operator Code
Using the Key Operator Programs
Each time a number is entered, the dashes (-) in the dis-
play will change to asterisks (). The factory default set-
ting for the key operator code number is 00000.
2-5