Stream Feeding Mode; Auto Paper Selection Setting; Registration Adjustment - Xerox WorkCentre C226 System Administration Manual

Key Operator Programs
NOTE:
2-26

Stream feeding mode

This program is used to enable the stream feeding mode of the DADF. When the
stream feeding mode is enabled, additional originals which are set in the DADF tray
within 5 seconds after the previous original was fed will be fed and copied automati-
cally.
The stream feeding mode will not function when the covers mode has been selected.

Auto paper selection setting

Use this program to select the paper type* for which the automatic paper selection
function operates. Selections are "Plain paper", "Plain paper and recycle paper", and
"Recycle paper".
* The paper type set for each paper tray in the paper tray settings of the user settings
(see your Xerox WorkCentre C226 User Guide).

Registration adjustment

Use this program when the colour of characters and lines in colour printing is off. Reg-
istration adjustment can be performed in two ways: manually and automatically. Nor-
mally [AUTO ADJUSTMENT] should be used.
[AUTO ADJUSTMENT]
Touch this key to have registration adjustment performed automatically.
After touching this key, touch the [EXECUTE] key. A message appears when auto-
matic registration adjustment is completed. Touch the [EXIT] key to exit.
[MANUAL ADJUSTMENT]
Touch this key to perform registration adjustment manually.
Use this key when you require a higher level of precision than can be obtained with
[AUTO ADJUSTMENT]. See page 13 for the procedure for manual registration adjust-
ment.
Xerox WorkCentre C226 System Administration Guide