Condition Setting Screen - Xerox WorkCentre C226 System Administration Manual

Scan Kit

Condition setting screen

Message
display
[ADDRESS
DIRECTORY] key
[SENDER LIST]
key
[ADDRESS
REVIEW] key
Scanner Fax
key
[E-MAIL
ADDRESS] key
Two-sided
scanning icon
display
[ORIGINAL] key
5-20
The display is initially set (factory setting) to show the following condition setting
screen as the initial screen.
Ready To Send.
Auto
Exposure
Lower
Resolution
Programmed
File Format
Auto
Original
Messages appear here to indicate the current status of the machine.
This displays the Address Directory screen (page 5-21). Touch this key when you wish
to use a one-touch key that has a destination (or group) programmed in it.
Touch this key to select the sender when sending an image.
When performing Scan to E-mail broadcast transmission, touch this key to check your
selected destinations. Your selected destinations will appear as a list, and the list can
be edited.
When the optional facsimile expansion kit is installed, touch this key to switch between
scanner mode and fax mode.
When performing Scan to E-mail, touch this key if you wish to enter the e-mail address
of the recipient manually instead of using an one-touch key.
Icons appear here when you touch the [ORIGINAL] key and select two-sided scan-
ning. The icons can be touched to open function selection screens.
Touch this key when you wish to manually set the size of the original to be scanned or
scan both sides of the original.
E-Mail Address
Scanner
Xerox WorkCentre C226 System Administration Guide
Address
Directory
Sender List
Address Review
Fax