List Print; Key Operator Code Change; Return From Copy Mode Timing - Xerox WorkCentre C226 System Administration Manual

List print

Key operator code change

Xerox WorkCentre C226 System Administration Guide

Return from copy mode timing

After printing ends in copy mode, this program is used to set the amount of time until
the mode is changed and printing begins of a job waiting in printer mode or fax mode.
The amount of time can be set from 0 second to 60 seconds in increments of 1 sec-
ond.
This program is used to print lists of key operator programs.
Lists of key operator programs for copier, fax, printer and network scanner features
are available.
This program is used to change the key operator code.
The key operator must register a key operator code number and use the number to
gain access to key operator programs. Only one key operator code number can be
registered. The factory has registered "00000" as the code number to allow initial
access to the programs. It is recommended that the key operator use the factory num-
ber for initial entry into the programs and then choose and enter another number by
this program.
General Programs
2-29