Fax Receive Settings; Auto Receive Reduce Setting - Xerox WorkCentre C226 System Administration Manual

Fax Unit
NOTE:
NOTE:
6-58
Country Differentiation Table
The number of recall
attempts
The interval between
attempts
If you do not want recalling to take place, touch the [TURN OFF RECALL] checkbox
so that a checkmark appears.
Even if this setting is turned on, your machine will not re-attempt the call when a
document is sent by manual transmission. (See "Sending a Fax after Talking (Manual
Transmission)" in your Xerox WorkCentre C226 User Guide.)

Fax receive settings

The receive settings allow you to adjust certain parameters for receiving faxes to bet-
ter suit your needs.
Settings that can be adjusted depend on the peripheral devices installed.
The "Fax receive settings" are as follows:
•

Auto receive reduce setting

• Number of calls in auto reception
• Duplex reception setting (only when the duplex module option is installed)
• Print style setting
• Set the telephone number for data forwarding
• Output tray setting
• Anti junk fax setting
Auto receive reduce setting
When you receive a fax that includes the sender's name, sender's number, and other
printed information, the received image will be slightly larger than the standard size*.
This setting lets you select whether or not the received image is automatically reduced
before printing to fit the standard size. Normally automatic reduction is enabled.
If auto receive reduce is disabled, an image larger than the standard size will be cut
off. However, the image is clearer because it is printed at the same size as the original.
* Standard sizes are sizes such as A4 and B5 (8-1/2"x11" and 8-1/2"x5-1/2").
United Kingdom
1 to 5
any number of minutes from 1 to 15
Xerox WorkCentre C226 System Administration Guide
Australia, New Zealand
and Singapore
1 to 9