Xerox WorkCentre C226 System Administration Manual page 123

NOTE:
NOTE:
NOTE:
Xerox WorkCentre C226 System Administration Guide
Number of Times Clear All Memory Program Is Repeated
This program is used to enhance the security function. The repeat count for "CLEAR
ALL MEMORY" can be set to any number from 1 to 7. The factory setting is 1.
Touch the [NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED]
key, and set the desired number of times with the
When finished, touch the [OK] key.
(See "About the repeat count setting" on page 4-7.)
About the repeat count setting
When the repeat count is increased to enhance the security function, the time required
for data clearing will increase. It is recommended that "NUMBER OF TIMES CLEAR
ALL MEMORY PROGRAM IS REPEATED" be set to the most suitable number for
your security requirements.
Power Up Auto Clear
This program automatically clears all data stored in the unit when the main switch is
turned on.
To enable "POWER UP AUTO CLEAR", touch the checkbox so that a checkmark
appears and then touch the [OK] key.
By default, a checkmark does not appear.
Note for models that have the fax function installed
Fax data not yet printed such as faxes received at night will not be cleared.
Print hold data that is stored on the hard disk will not be cleared.
If you wish to cancel after data clearing has begun
See the explanations in "[Clear screen 2]" and "NOTE" in "Clear All Memory" on
page 4-6.
Key Operator Programs
or key.
4-7