Storing A Program - Xerox WorkCentre C226 System Administration Manual

Fax Unit

Storing a Program

NOTE:
6-24
You can store a destination fax number, polling, dual page scan, and resolution and
exposure settings in a program. This enables you to call up the program and perform
the transmission by means of a simplified operation.
To store a program, follow steps 1 through 3 beginning on page 6-9, touch the [PRO-
GRAM] key in step 4, and then follow these steps.
A timer setting cannot be included in a program.
When storing a program for an F-Code operation, one touch keys for destinations
must include sub-addresses.
1. Touch the [PROGRAM NAME] key.
Program
No.1
Program Name
Address
Settings
Resolution
Special
Modes
2. Touch the [SETTINGS] key.
No.1
Program For Xerox
Program Name
Address
Settings
Resolution
Special
Modes
The "No." that automatically appears is the lowest num-
ber from 1 to 8 that has not yet been programmed.
When the [PROGRAM NAME] key is touched, the letter-
entry screen appears. Enter up to 18 characters for the
name.
Xerox WorkCentre C226 System Administration Guide