Xerox WorkCentre C226 System Administration Manual page 91

NOTE:
Xerox WorkCentre C226 System Administration Guide
Installing the printer driver (standard installation)
The procedure for a standard installation of the printer driver is explained below. This
procedure is normally used when the printer driver will be used with a network connec-
tion.
To use the machine as a network printer in Windows NT 4.0, "TCP/IP Protocol" and
"Microsoft TCP/IP Printing" must be installed on your computer. Make sure these are
installed. If either is not installed, install as explained in Windows NT 4.0 Help.
When installing the printer driver, if you wish to install a display font or specify the IP
address of the machine by direct entry, select [Custom installation] (page 3-7).
1. Insert the WorkCentre C226 PostScript Drivers CD-ROM that accompanied the
machine into your CD-ROM drive.
2. Click the [start] button, click [My Computer], and then double-click the CD-ROM
icon.
In Windows 95/98/Me/NT 4.0/2000, double-click [My Computer], and then double-
click the CD-ROM icon.
3. Double-click the [SETUP] icon.
4. The Licence Agreement window will appear. Make sure that you understand the
contents of the licence agreement, and then click the [Yes] button.
5. After confirming the message in the "Welcome" window, click the [Next] button.
6. Click the [Printer Driver] button.
To view detailed information on the software, click the [Display Readme] button.
7. Click the [Next] button.
Requirements for Windows
3-5