Disabling Of Finisher; Saddle Stitch Position Adjust - Xerox WorkCentre C226 System Administration Manual

Xerox WorkCentre C226 System Administration Guide

Disabling of finisher

This program is used to disable use of the saddle stitch finisher when it malfunctions.

Saddle stitch position adjust

This program is used to adjust the stapling position (folding position) when using the
saddle stitch function of the optional saddle stitch finisher.
The value can be adjusted in 0.1 mm increments within ±3.0 mm from the reference
position for each paper size.
Max. +3 mm
Position adjusted
to the plus
direction
1
2
Reference position
[AUTOMATIC SADDLE STITCH] checkmark
The saddle stitch print function can normally be divided into the following three general
steps.
1. The pages of the original are automatically reordered to allow saddle stitch binding
(saddle stitch function).
2. The pages are folded at the centre.
3. The paper is stapled at the centre in two places (saddle stitch stapling).
The [AUTOMATIC SADDLE STITCH] checkbox is selected by default.
Selection of the checkbox assumes the use of the above saddle stitch printing function
(three steps).
Saddle stitch stapling exceptions
Depending on the purpose of saddle stitch stapling, it may be necessary to perform
saddle stitch stapling on printed matter that has already been bound by saddle stitch-
ing. In this case, it is necessary to disable step 1 above. If you frequently perform this
type of exceptional saddle stitch stapling that requires disabling step 1, remove the
checkmark from the [AUTOMATIC SADDLE STITCH] checkbox.
Min. -3 mm
Position adjusted
to the minus
direction
12
11
General Programs
2-25