Key Operator Program List - Xerox WorkCentre C226 System Administration Manual

Key Operator Programs

Key Operator Program List

NOTE:
2-2
Programs for the copy function
These programs are used to change the factory default copy settings to settings that
better suit the needs of your workplace.
Programming a key operator code
The key operator code is a 5-digit number that must be entered in order to access the
key operator programs. The key operator (administrator of the machine) should
change the default key operator code that was set at the factory to a new 5-digit num-
ber. Be sure to remember the new key operator code, as it must be entered each time
the key operator programs are subsequently used. (Only one key operator code can
be programmed.)
The key operator code is initially set to "00000" at the factory.
To change the key operator code, see "Using the Key Operator Programs" on page 2-
5.
The following list shows programs that are common to all functions of the machine
(copy, fax, printer, and network scanner functions) and programs that are specifically
for the copy function.
Key operator programs can only be accessed after a key operator code number has
been entered.
The key operator programs that can be accessed depend on the optional equipment
that is installed.
Xerox WorkCentre C226 System Administration Guide