Abbott aim Technical & Service Manual page 95

Section 7, Replaceable Parts and Repairs
Front case assembly
(Connections identical
for AIM and AiM Plus)
FFC jumper (J7)
Battery connector cable (J6)
Bolus jack cable (J1)
AC power jack cable (J13)
Number keypad ribbon (J3)
Function keypad ribbon (J14)
Bolus keypad ribbon (J15)
Motor frame seal
(not present on
all configurations of
AIM Plus)
AIM Plus back case assembly
(AIM beeper placement is different)
5B.BA 75
Figure 7-2. Front Case Connections
5. Turn the pump over and lift the front case away from the unit.
6. Disconnect the battery connector cable, bolus jack, and AC power jack pins from the circuit
board (refer to Figure 7-2. Front Case Connections).
7. Disconnect the number, function, and bolus keypads and the display module from the circuit
board by pulling up the locking bars and sliding the keypad ribbons and the FFC jumper out of the
connectors (refer to Figure 7-2. Front Case Connections).
8. Remove the front case and set aside.
For further repair instructions regarding the front case and its components or the display module,
refer to Section 7.10, Front Case Assembly or Section 7.11, Display Module.
AIM/AIM Plus Technical Service Manual 7-3 430-600035-002 (Rev. 11/99)