Table of Contents
Advertisement
6.3.2.1
Function Alarms 001-007
Section 6, Troubleshooting
Table 6-2. AIM/AIM Plus Alarm Codes 001 - 007
Solution
Press [SILENCE] to mute for one minute.
Press [STOP]. Disconnect patient from set
and follow appropriate prime procedure.
Note: Priming not available in Full Lock.
if alarm will not clear, refer to page 6-19,
#9 in Table 6-5. Troubleshooting.
Press [SILENCE] to mute for one minute.
Check that latch is closed. Check cartridge
installation: close slide clamp, remove
cartridge, realign dot in red circle on
cartridge, and reinsert cartridge in pump.
If alarm will not clear, refer to page 6-18,
#7 in Table 6-5. Troubleshooting.
Press [SILENCE] to mute for one minute.
Press [STOP]. Check that latch is closed.
Check for occlusion and correct problem.
Check cartridge installation: close slide
clamp, remove cartridge, realign dot in red
circle on cartridge, and reinsert cartridge in
pump.
If alarm will not clear, refer to page 6-18,
#7 in Table 6-5. Troubleshooting.
Press [SILENCE] to clear.
Press [START], [STOP], or [SILENCE] to
clear. Check for secure AC connection and
restore AC power as necessary.
Press [STOP], then power off. Replace
batteries, or connect pump to AC power,
then power on.
Power off to mute. Replace batteries, or
connect pump to AC power.
Code and Message
Cause
001 | AIR IN LINE or
Air has been detected in
2 mL AIR
line.
DETECTED
002 | CHECK
Cartridge is not installed or
CARTRIDGE
improperly installed when
the START key was
pressed.
003 | OCCLUSION
Blockage in the line between
pump and patient, or
cartridge is improperly
installed.
004 | PRIME OVERUSE
Operator has primed the .
pump for more than two
minutes.
005 | USING BATTERIES | Pump was powered by AC
adapter, but is now using
.
battery power.
006 | LOW BATTERIES
| Pump is powered by
batteries and battery voltage
is now below 4.0 volts.
007 | POWER LOSS
AC adapter was
disconnected, batteries were
removed, or batteries are
dead.
AIM/AIM Plus Technical Service Manual
6-5
430-600035-002 (Rev. 11/99)
Advertisement
Table of Contents
Troubleshooting
