Latch Spring - Abbott aim Technical & Service Manual

Section 7, Replaceable Parts and Repairs
7.8.1
Latch Spring
Equipment/Material Required:
© Allen Wrench
Q Loctite® Threadtocker 222
Note: The pump does not require disassembly to replace the spring. To access the spring, slide the
latch down, then out. The PVT is not required if the pump is not disassembled.
To replace the spring only:
1. Use Allen wrench to remove set screw (refer to ).
2. Remove the spring to be replaced. Place the new spring in the lever arm cavity.
3. Apply Threadlocker to the threads of the set screw and insert the screw into the cavity; do not get
Threadlocker in the spring area. Tighten the screw,
4. Check the ejector slide for free movement. -
430-600035-002 (Rev. 11/99) 7-16 ALMAM Plus Technical Service Manual