Abbott aim Technical & Service Manual page 53

Section 5, Maintenance and Service Tests
5.3.3
Delivery Test
This test verifies the motor operation through a "dry" test that measures motor turns or through a
"wet" test that measures fluid delivered.
5.3.3.1
Pump programming
Install four AA batteries. Switch the pump on and wait for the self-test to complete. Because only
batteries are in use, the following display appears:
USING BATTERIES Press [ENTER].
ENTER TO CONFIRM
1 TPN Press [2] to select pain management therapy.
2 PAIN MANAGEMNT
3 INTERMITTENT
USE FOR MORE
1 INTRAVENOUS Press [2] to select epidural mode.
EPIDURAL
3 SUBCUTANEOUS
CONTINUOUS Press [2] to select bolus only delivery.
BOLUS ONLY
3 CONT. + BOLUS
1 SELECT mg/mL Press [3] to select mL as the delivery unit.
2 SELECT ug/mL
3 SELECT mL
PROGRAM A Press [YES] to program a loading dose.
LOADING DOSE?
YES OR NO
SET LOADING DOSE For Dry Test: Press [1] [0] and [ENTER] to select 10 mL.
0.0 mL For Wet Test: Press [2] [0] and [ENTER] to select 20 mL.
ENTER WHEN DONE
DELIVER THE Press [NO] to save the loading dose for later delivery.
LOADING DOSE
NOW?
YES OR NO
AIM/AIM Plus Technical Service Manual 5-21 430-600035-002 (Rev. 1 1/99)