Abbott aim Technical & Service Manual page 52

Section 5, Maintenance and Service Tests
5.3.2.21
Print Test Results
Q Test Setup:
- Connect the printer to the pump (for setup instructions, refer to the System Operating
Manual).
PRINT ATP TESTS:
CONNECT PRINTER
AND PRESS START.
STOP TO CANCEL.
5.3.2.22
Printer Test
01 VERSION #
02 CLEAR EAT RAM
03 CLEAR ERR LOG
USE + FOR MORE
5.3.2.23
Power Loss Alarm
Press [START] to print the test results.
Attach the printout to the PVT.
At the Service Test Mode menu press [1] [7] to enter the PRINTER
TEST.
The pump will send a copy of the character set to the printer. Verify
the printout reads as follows:
PRINT TEST START
ABCDEFGHIJKLMNOPORSTUVWXYZabcdefghijklmn
opgrstuvwxyz0123456789.: *,UABCDEFGHIJKL
MNOPORSTUVWXYZabcdefghijklmnopgrstuvwxyz
0123456789.: *,UABCDEFGHIJKLMNOPORSTUVWX
PRINT TEST COMPLETE
Attach the printout to the PVT.
Disconnect the external power supply and battery substitution block. Verify that the power loss alarm
sounds for at least 30 seconds, Hf using the PVT Form, record the results.
430-600035-002 (Rev. 11/99)
5-20 AIM/AIM Plus Technical Service Manual