FUTABA T10PX Full Manual page 80

Home screen
Steering end point adjustment
(Preparation)
- Before setup of the steering end point adjustment, set the steer-
ing D/R dial (initial setup: DT5) to the maximum steering angle
position 100%.
- Tap the travel button of the [Steering Left]. Value input buttons
appear on the screen and make the following adjustments:
1
Steering (left side) adjustment.
Turn the steering wheel entirely to the left and use
the [+] or [-] buttons to adjust the steering angle.
2
Steering (right side) adjustment.
Turn the steering wheel entirely to the right and
use the [+] or [-] buttons to adjust the steering
angle.
Note
Step #1 & #2 are done when the receiver is in the on position installed on
the chassis. You're watching the wheels reach their maximum end point.
3
When finished, return to the Linkage menu screen by press-
ing the HOME button.
When EPA trim is turned on, the steering angle (end point) can be adjusted
by steering trim set digital trim or dial. (Steering trim initial setting: DT1)
-Steering left side adjustment
With the steering w hee l turned
fully to th e lef t, ste erin g is ad -
justed by steering trim and tem-
porarily displayed at this par t of
the HOME screen, as shown in
the figure below.
LINKAGE MENU
Menu screen
Menu-1
Quick EPA
L
Linkage menu
Linkage menu screen
Menu-2
DT1
R
End point
Tap to change page
The number of channels varies de-
pending on the selected system.
Adjustment buttons
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Steering End point: 0~140
Initial value: 100
-Steering right side adjustment
With the steering w heel turned
fully to the right, steering is ad-
justed by steering trim and tem-
porarily displayed at this part of
the HOME screen, as shown in
the figure below.