FUTABA T10PX Full Manual page 127

1
(Preset position setup)
Tap the value button of the [Preset]. Value
input buttons appear on the screen. Use the
[+] and [-] buttons to set the preset position
of the throttle servo.
2
When finished, return to the Linkage menu screen by pressing the HOME button.
Trim/Dial Setting
7 H IXQFWLRQ VHOHFW WULP GLDO IXQFWLRQ FDQ FRQWURO W H HQJLQH FXW SUHVHW SRVLWLRQ LW
W H GLJLWDO GLDO RU GLJLWDO WULP /LQNDJH PHQX
7 H W URWWOH VHUYR RSHUDWLQJ SRVLWLRQ SUHVHW SRVLWLRQ VHW E\ W LV VHWWLQJ LV XQUHODWHG
to the environment of other functions. Maximum to minimum servo travel can be
VHW +R HYHU W H UHYHUVH IXQFWLRQ VHWWLQJ LV HQDEOHG
Caution
Always operate carefully before using this function.
When push switch, or trigger switch TS with preset function set is in the ON state, the servo (motor controller) is
locked in the preset position and does not operate even if the throttle trigger is operated. If the servo was oper-
ated at the wrong setting, you may lose control of the car (boat).
RACING MENU
*Shows the ON/OFF state
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Preset position
0~100
Initial value: 0