FUTABA T10PX Full Manual page 5

8VH WKLV SURGXFW L D VDIH PD HU 3OHDVH REVHUYH WKH IROORZL
For safety's sake, pay special attention whenever you see the marks shown here.
For safe use
Danger
Procedures which may lead to dangerous conditions and cause death/serious injury if not carried out properly.
Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or
Warning
procedures where the probability of superficial injury or physical damage is high.
Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, i f
Caution
not carried out properly
Symbols:
Warning
Special attention should be paid before turning on the system while other cars are running or other air-
planes are flying because the 2.4GHz RC system could potentially affect them.
Be sure to set the Fail-safe function.
Caution
Be sure to use the T10PX receiver setting and the servo to be used under predetermined conditions.
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In addition, it
may cause servo trouble. Futaba will not be responsible for problems caused by the use of other than genuine Futaba parts. Use the
parts specified in the instruction manual and catalog.
For servos for which the operation mode can be set, change the servo operation mode according to the system to be used. If the
operating modes of the system and servo are different, it will fail.
Use SR servo for SR mode.
When the SR mode is ON, it is exclusively for our SR compatible servo. Using a servo other than the SR compatible servo may
cause the servo or receiver to malfunction.
If a normal servo is connected to a CH with SR mode ON, there is a risk of damage.
Do not connect SR servo (set to SR mode) and analog servo in digital servo mode.
Do not connect SR servo (set to SR mode) in analog servo mode.
SR servo can be used digital or analog when set to normal mode.
Connecting an SR mode compatible servo set to SR mode to the S (S.BUS2 port) may cause malfunction of the servo or receiver.
Receiver battery: Matched to the ratings of the receiver and connected servo (dry cell battery cannot be used).
Fail-safe Unit cannot be used because the system is different. Use the fail-safe function of the transmitter.
For Your Safety As Well As That Of Others
Explanation Of Symbols
: Prohibited
2.4GHz System Precautions
Receiver Mode Precautions
VDIHW SUHFDXWLR V DW DOO WLPHV
: Mandatory