FUTABA T10PX Full Manual page 143

2
(Channel setup)
The channel list screen used for the front ESC channel is displayed. Tap the auxiliary chan-
nel that connected the front ESC channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (Linkage menu).
3
(Drive ratio adjustment)
Adjust the front and rear motor controller
operation amount by
button increases and the
the rear ratio.
Both the front and rear ratios become 100%
4
(Mix mode setting)
Tap "MIX mode" (ON) or (OFF) to select ON/OFF.
"OFF": The EXP function of the 2nd CH and other settings are not mixed.
"ON": The EXP function of the 2nd CH and other settings are mixed.
5
(Trim mode setup)
Tap "Trim mode" (ON) or (OFF) to select ON/OFF.
"OFF": The trim of the 2nd CH is not mixed.
"ON": The trim of the 2nd CH is mixed.
6
When finished, return to the Mixing menu screen by pressing the HOME button twice.
Trim/Dial Setting
7 H WULP GLDO VHOHFW IXQFWLRQ FDQ FRQWURO W H GULYH UDWLR
WULP /LQNDJH PHQX
Note:
V W LV IXQFWLRQ GULYHV W R VHSDUDWH PRWRU FRQWUROOHUV VLPXOWDQHRXVO\ D PXWXDO ORDG
LV DSSOLHG 8VH W LV IXQFWLRQ FDUHIXOO\ VR W DW W H PRWRU FRQWUROOHUV DUH QRW GDPDJHG
)XWDED LOO QRW EH UHVSRQVLEOH IRU PRWRU FRQWUROOHU PRWRU DQG RW HU YH LFOH WURXEOH GXH
WR W H XVH RI W LV IXQFWLRQ
The number of chan-
nels varies depending
on the selected sys-
tem.
or button. The
button decreases
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
Adjustment buttons
- Adjust with the
- Return to the initial value by
tapping the [reset] buttons.
Rear rate (Rear mix rate)
0~100
Initial value: 100
Setting
- Tap (ON)/(OFF).
Setting
- Tap (ON)/(OFF).
LW W H GLJLWDO GLDO RU GLJLWDO
and buttons.