FUTABA T10PX Full Manual page 165

Alarm and Vibrator function setup
1
(Limit adjustment)
Tap the " Limit] or "
" [
the screen.
Use the [+] or [-] button to adjust the limit voltage.
2
(Alarm and vibrator function setup)
Tap the " " [Alarm] type and select [Inhibit], [Buzzer]or
"/ "
[Voice].
"Inhibit": No audible alarm/ "Buzzer": Audible alarm/ "Voice": Voice alarm
Tap the " " [Vibrator] type and select [Inhibit], [Type 1],
"/ "
[Type 2], or [Type 3].
"Inhibit": No active vibration
"Type 1": Continuous vibration
"Type 2": Intermittent vibration for a long time
"Type 3": Intermittent vibration for a short time
3
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON/OFF.
"OFF": No voice guide
"ON": Information loaded by voice
4
When finished, return to the Telemetry screen by pressing the HOME button.
How to set the reference position
It takes a while for GPS to be measured after turning on the power. Please wait until the LED
of the GPS sensor turns on the green without moving the car body. If the distance display
does not stabilize even after the green LED lights up, or if you set a new reference value for
the place where the car body moved, reset the reference position.
1
(reset operation)
Since either the distance/speed screen can be used, tap [Reference
position setting]. The distance is reset. After that, the distance from
the point where resetting is done is displayed until tapping [Reference
position setting] again.
Limit]. Value input buttons appear on
" [
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Setting
- Tap alarm type.
Inhibit/Buzzer/Voice
Setting
- Tap Vibrator type.
Inhibit/Type 1/Type 2/Type 3
Setting
- Tap (ON)/(OFF).
*The voice guide loading inter-
val is set by sensor menu.