FUTABA T10PX Full Manual page 38

7KH 7 3 D G ) * UHFHLYHU 5
RU 6L FH R O R H UHFHLYHU , LV PHPRUL]HG DW HDFK PRGHO PHPRU PXOWLSOH ) * 7 )+66 UHFHLYHUV FD RW EH XVHG ZLWK
WKH VDPH PRGHO PHPRU :KH D UHFHLYHU DW WKH VDPH PRGHO PHPRU LV FKD HG UH OL NL
HU LV DOUHDG OL NHG ZLWK WKH WUD VPLWWHU
:KH XVL PXOWLSOH ) * 7 )+66 UHFHLYHUV OL N HDFK UHFHLYHU ZLWK HDFK 7
FD EH OL NHG ZLWK PXOWLSOH PRGHO PHPRULHV
7KH WHOHPHWU IX FWLR FRPPX LFDWLR VWDWXV FD EH FKHFNHG DW WKH 7 3 KRPH VFUHH
*For other than F-4G system, the link procedure is di erent.
S-FHSS/FASST Receiver Link
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the power switch (PWR). On the display (DSP) side,
you cannot link.
3
Turn on the receiver.
4
Push the push switch of the receiver.
When the link is complete, the LED in the receiver changes to solid green. Check the
operation of the servo.
Precaution:
If there are many Futaba 2.4GHz systems turned on close to your receiver might not link to your transmitter. In this case,
even if the receiver's LED stays solid green, unfortunately, the receiver might have established a link to one of the other
transmitters. It is dangerous if you do not notice this situation. To avoid problems, it is strongly recommended that you
double-check that the transmitter controls the receiver by making the wheel or trigger inputs and checking the servo re-
sponse.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched.
Unrecoverable failure (EEPROM,etc.)
/( FRXOG EH FKD HG WR UHG GXUL
6 6 5 6 6 ( 7 )+66 UHFHLYHU PHPRUL]H WKH , V OL NHG ODVW DW HDFK PRGHO PHP
L WHUPLWWH WO GXUL GDWD SURFHVVL
LV HFHVVDU HYH LI WKH UHFHLY
3 PRGHO PHPRU +RZHYHU R H UHFHLYHU
Red: On
Green: On
*1
Green: Blink (T-FHSS, Red: On)
LED: Red and Green turn on alternately