FUTABA T10PX Full Manual page 18

Battery Replacement Method
/RDG WKH IRXU EDWWHULHV L DFFRUGD FH ZLWK WKH SRODULW PDUNL V R WKH EDWWHU KROGHU
Battery Replacement Method
1
Remove the battery cover from the transmitter by
sliding it in the direction of the arrow in the figure.
2
Remove the used batteries.
Caution
If you remove the dry cell battery box from the transmit-
ter, replace it carefully with the wiring on the same side
as before. Reinstalling the battery box in the opposite
direction could cause the wires to be disconnected.
3
Load the new AA size batteries. Pay very close
attention to the polarity markings and reinsert ac-
cordingly.
4
Slide the battery cover back onto the case.
Disposal of the Dry Cell Batteries:
The method to dispose of used dry cell batteries depends on the area in which you reside. Dispose of
the batteries in accordance with the regulations for your area.
Caution
When running (cruising), do not use the dry cell battery box at the transmitter.
The accessory dry cell battery box is for performance checks. Do not use it for other than performance checks. The dry
cell batteries will be separated from the battery box contacts by shock and the power may be cut off. There is the dan-
ger of collision if the power is cut while running (cruising). The use of Futaba genuine NiMH/LiFe or LiPo batteries is
strongly recommended.
Low Battery Alarm
,I WKH WUD VPLWWHU EDWWHU YROWD H GURSV EHORZ WKH XVDEOH UD H D DXGLEOH DODUP ZLOO
VRX G D G " /RZ EDWWHU " ZLOO EH GLVSOD HG 6L FH WKH XVDEOH UD H RI 1L0+ /L)H
batteries and LiPo batteries is di erent, the power supply used must be set by system
VHWWL ,I WKH EDWWHU
FROOLVLR LPPHGLDWHO UHFRYHU WKH YHKLFOH ERDW D G VWRS UX
Warning
When a low battery alarm is generated, cease operation immediately and retrieve the model.
If the battery goes dead while in operation, you will lose control of the model.
RHV GHDG ZKLOH UX L
Slide battery cover while pressing here.
FUXLVL VL FH WKHUH LV WKH GD HU RI
L FUXLVL
Battery cover