FUTABA T10PX Full Manual page 72

6
During the 20 seconds link mode, press the receiver for at least 2 seconds. The LED
blinks red and then changes to a greenish red
makes a beeping sound and the message "Link with receiver" appears on the screen,
release the receiver push switch. This ends reading of mutual ID and displays the
memorized receiver ID number on the T10PX screen. Power cycle the receiver. If the
"Receiver not found" error screen is displayed, linking failed. Check the set contents and
repeat the linking operation.
Link established
The link is completed.
7
Once the settings are complete, turn the receiver off and then on again. The response
and battery fail-safe voltage settings will take effect after the receiver is restarted.
7 H 7 3 DQG ) * UHFHLYHU 5
PHPRU\ 6LQFH RQO\ RQH UHFHLYHU ,' LV PHPRUL]HG DW HDF PRGHO PHPRU\ PXOWLSOH ) * 7 )+66 UHFHLYHUV FDQQRW EH XVHG
LW W H VDPH PRGHO PHPRU\ : HQ D UHFHLYHU DW W H VDPH PRGHO PHPRU\ LV F DQJHG UH OLQNLQJ LV QHFHVVDU\ HYHQ LI W H
UHFHLYHU LV DOUHDG\ OLQNHG LW W H WUDQVPLWWHU
: HQ XVLQJ PXOWLSOH ) * 7 )+66 UHFHLYHUV OLQN HDF UHFHLYHU
FDQ EH OLQNHG LW PXOWLSOH PRGHO PHPRULHV
7 H WHOHPHWU\ IXQFWLRQ FRPPXQLFDWLRQ VWDWXV FDQ EH F HFNHG DW W H 7 3
*For other than F-4G system, the link procedure is di erent.
LINKAGE MENU
6%6 5 6%6 ( 7 )+66 UHFHLYHU PHPRUL]H W H ,'V OLQNHG ODVW DW HDF PRGHO
LW HDF 7
green steady light. When the T10PX
Link failed
Repeat the linking operation
3 PRGHO PHPRU\ +R HYHU RQH UHFHLYHU
RPH VFUHHQ