FUTABA T10PX Full Manual page 140

2
(Channel setup)
The channel list screen used for rear steering is displayed. Tap the auxiliary channel that
connected the servo of rear steering.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (Linkage menu).
- T10PX can also be used for rear steering by setting the throttle to other auxiliary channels setting function and
making the Ch.2 assignable channel (Linkage menu).
The number of channels
varies depending on the
selected system.
3
(4WS type selection)
Tap the 4WS type and select [Type 1], [Type 2], [Type 3] or
[Type 4].
"Type 1": Function OFF (front only)
"Type 2": Front side only, reverse phase switching
"Type 3": Front side only, reverse phase and same phase switching
"Type 4": Front side only, reverse phase, same phase, and rear side only switching
Switched in the order shown in the figure below by the as-
signed switch.
Type 2
Front side only, Reverse
phase switching
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
Type 3
Front side only, Reverse phase
and same phase switching
To set the throttle
to another auxiliary
channel and use it
for ste ering 2, tap
[Yes] . To can ce l ,
[No] is tapped.
Setting
- Tap 4WS type.
Type 1/Type 2/Type 3/Type 4
Type 4
Front side only, reverse phase, same
phase, and rear side only switching
Switch by tapping
the car icon