FUTABA T10PX Full Manual page 159

Telemetry: The Drive Battery Voltage
This function displays and sets the voltage of an external power supply (drive battery,
HWF VHSDUDWHO\ LQVWDOOHG LQ W H F DVVLV 5HFHLYHU 6 %86
6%6 9 VHQVRU DQG EDWWHU\
* A drive battery sensor must be installed in the model car. Install and connect the sensor following the sensor in-
struction manual.
Telemetry
Sets the limiter voltage
(Voltage that sounds an alarm)
Alarm and Vibrator function setup
1
(Limit adjustment)
Tap the [Limit]. Value input buttons appear on the screen.
Use the [+] or [-] button to adjust the limit voltage.
2
(Alarm function setup)
Tap the [Alarm] type and select [Inhibit], [Buzzer]or [Voice].
"Inhibit": No audible alarm
"Buzzer": Audible alarm
"Voice": Voice alarm
3
(Vibrator function setup)
Tap the [Vibrator] type and select [Inhibit], [Type 1], [Type 2],
or [Type 3].
"Inhibit": No active vibration
"Type 1": Continuous vibration
"Type 2": Intermittent vibration for a long time
"Type 3": Intermittent vibration for a short time
4
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON/OFF.
"OFF": No voice guide
"ON": Information loaded by voice
5
When finished, return to the Telemetry screen by pressing the HOME button.
FRQQHFWRU LV XVHG WR FRQQHFW
Current drive battery voltage
The minimum and maximum when
powering ON are shown.
Alarm/vib rator ON/OFF and type
setting (The arrow indicates that an
alarm is generated when the power
supply voltage drops below the set
value.)
The Speech function (ON/OFF)
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Setting
- Tap alarm type.
Inhibit/Buzzer/Voice
Setting
- Tap Vibrator type.
Inhibit/Type 1/Type 2/Type 3
Setting
- Tap (ON)/(OFF).
*The voice guide loading inter-
val is set by sensor menu.