FUTABA T10PX Full Manual page 164

: HQ 6%6 * * *36 VHQVRU VROG VHSDUDWHO\ LV PRXQWHG RQ W H FDU ERG\ \RX FDQ
UHFHLYH UDGLR DYHV IURP *36 VDWHOOLWHV DQG GLVSOD\ LQIRUPDWLRQ RQ W H GLVWDQFH DQG
VSHHG RI W H FDU
* A GPS sensor must be installed in the model car. Install and connect the sensor following the sensor instruction
manual.
* When powered up, the SBS-01/02G begins to acquire GPS satellite data. This process can take several minutes.
Please do not move the model during this process. During acquisition, the LED on the SBS-01/02G will blink
green; after the satellite's signals have been acquired, the LED will become solid green, and the GPS signal
strength display on the transmitter will show three bars.
Moving the model before the satellites are fully acquired will cause a delay in acquiring the satellite signal.
* Since GPS satellites are basically used, accurate distances and speeds may not be displayed depending on the
surrounding environment or the conditions of the course. It cannot be used indoors.
Telemetry
This indicates the
receiving accuracy
from a GPS Satel-
lite.
The position of the pres-
ent model is displayed.
-Upper side:
Current distance and speed display.
-Lower:
This is a display of the maximum value of the
measured distance and speed after turning on
the transmitter power.
* Tap the max display button to restart the mea-
surement.
Telemetry: GPS
The Speech function
(ON/OFF)
The Speech function
(ON/OFF)
Current distance
Th e maximu m when powering
ON are shown.
* Tap the max display button to
restar t the measurement.
Alarm and vibrator ON/OFF and
type setting (The arrow indicates
that an alarm is generated when
the minimum distance below the
set value and the arrow indicates
that an alarm is generated when
the distance exceed s the set
value.)
Tap the [Preset reference]. Sets
the current car position as the
starting point.
Current speed
Th e maximu m when powering
ON are shown.
* Tap the max display button to
restar t the measurement.
Alarm and vibrator ON/OFF and
type setting (The arrow indicates
that an alarm is generated when
the minimum speed b elow the
set value and the arrow indicates
that an alarm is generated when
the speed exceeds the set value.)
Tap the [Preset reference]. Sets
the current car position as the
starting point.