FUTABA T10PX Full Manual page 187

This is used when stopping hunting, etc., but the holding characteristic changes as shown
below.
[Relationship between stretcher and servo operation]
Small - Servo holding force becomes weaker.
Large - Servo holding force becomes stronger.
(Note)
When this parameter is large, the current consumption increases.
Boost/Boost (ON/OFF)
INH: Boost is ON at the time of low-speed operation. (Normal)
ACT: Boost is always ON. (For quick operation).
The minimum current applied to the internal motor when starting the servo can be set.
Since a small travel does not start the motor, it essentially feels like the dead band was ex-
panded. The motor can be immediately started by adjusting the minimum current, which can
start the motor.
[Relationship between boost set value and servo operation]
Small - Motor reacts to a minute current, and operation becomes smooth.
Large - Initial response improves and output torque increases. However, if the torque is too large, the operation will
become rough.
Channel
This is the S.BUS system channel assigned to the servo. When connected to the receiver
S.BUS2 connector as an S.BUS system, the channel used by the transmitter is assigned.
When the normal receiver channel is used, the channel setting is unnecessary.
Reverse
The direction in which the servo rotates can be changed.
Soft Start
Restricts operation in the specified direction the instant the power is turned on. By using this
setting, the first initial movement when the power is turned on slowly moves the servo to the
specified position.
Neutral
The neutral position can be changed. When the neutral offset is a large value, the servo's
range of travel is restricted on one side.
Stop Mode
The state of the servo when the servo input signal is lost can be specified. The "Hold" mode
setting holds the servo in its last commanded position even if using AM or FM system.
Speed
Speeds can be matched by specifying the operating speed. The speed of multiple ser-
vos can be matched without being affected by motor fluctuations. This is effective for load
torques below the maximum torque.
However, note that the maximum speed will not exceed what the servo is capable of even if
the servos operating voltage is increased.
Travel [Left]/[Right]
The maximum left and right travel centered about the neutral position can be set indepen-
dently.