FUTABA T10PX Full Manual page 203

7 LV IXQFWLRQ LV GHVLJQHG IRU SDQ FDUV 7 H UROO RXW F DUW FDQ EH FDOFXODWHG IURP LQSXW YDO
XHV IRU W H QXPEHU RI WHHW RI W H VSXU JHDU DQG SLQLRQ JHDU DQG W H WLUH GLDPHWHU DQG GLV
SOD\HG DV D WDEOH
Home screen
Use of Roll out chart function
1
(Setting of a step of the tire diameter input)
Tap the value button of the [Step]. Value in-
put buttons appear on the screen. Use the [+]
and [-] buttons to set the Step of the numerical
input value of the tire diameter amount.
- The step amount can be set in the range of 0.1-mm to
1.0-mm.
2
(Setting of number of teeth of spur gear)
Tap the value button of the [Spur]. Value input buttons appear on the screen. Use the [+] and [-]
buttons to set the spur gear. The roll out is then calculated, and the list is updated.
3
(Setting of number of teeth of pinion gear)
Tap the value button of the [Pinion]. Value input buttons appear on the screen. Use the [+]
and [-] buttons to set the pinion gear. The roll out is then calculated, and the list is updated.
4
(Setting of tire diameter)
Tap the value button of the [Diameter]. Value input buttons appear on the screen. Use the [+]
and [-] buttons to set the tire diameter. The roll out is then calculated, and the list is updated.
5
When finished, return to the Accessory menu screen by pressing the HOME button.
Roll Out Chart
Menu screen Accessory menu screen Roll out chart
Setup item
Pinion
Spur
Step
Diameter
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.