FUTABA T10PX Full Manual page 25

8
Fit the rear cover and attach the APA to
the steering housing with three M2x10
screws and one M2x6 screw.
APA uses the inside holes. The mounting angle in
the direction of rotation can be adjusted.
position
Steering housing
Adjust the angle with the position mark.
9
Attach the wheel unit to the APA with
four M2×19 screws.
Adjust the angle with the position mark.
1 0
Install the assembled steering unit to
the transmitter body.
- From left to right, the
order is 2 pin connec-
tor, 15 pin connector,
4 pin connector.
- Install slowly so that
t h e w i r i n g i s n o t
pinched.
1 1
Attach the assembled steering unit
to the body with two M3x12 screws.
(Using a hex wrench.)
1 2
Insert the wheel and hold the wheel
and attach the screw.
(Using a hex wrench.)
Normal
screw
APA
APA
Wheel unit
2 pin 4 pin
Rear cover
*The rear cover depends on the size of the APA.
- Use the accessory screws and the
transmitter screws.
-There are extra screws in the accesso-
ries.
- Do not overtighten these four screws.
M3×12
M2×10
M2×10
M2×10
M2×6
M2×19
M3×12