FUTABA T10PX Full Manual page 184

2
(S.BUS/S.BUS2 servo read)
Execute this function to read the connected servo
type and the data currently set at the servo.
Tap the [Read] button. The notes on the wireless
settings are displayed. Tap the [Close] button.
Once this screen is displayed, it will not be displayed
again until you turn the power back on. Next, Touch
the channel in which the servo to be set is connect-
ed and read the setting data from the servo.
- Communication port: 10PX communication port (conventional wired setting).
- Wireless 1 (Rx Ch1): Receiver channel 1
- Wireless 2 (Rx Ch2): Receiver channel 2
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to
the servo. Tap the [Write]; the confirmation screen
is displayed. To execute, tap [Yes] to hear an elec-
tronic sound and finish setting. To cancel, select
[No] and tap it.
-"Writing succeeded" is displayed on the screen, and the set-
ting data is written to the servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed usually. Check the T10PX and
servo connection or receiver and servo connection to the ser-
vo and repeat [Write]. (Check receiver power supply, etc.)
4
(Initialization)
Write the factory set servo setting data to the connected servo. Tap the [Reset]; the confir-
mation screen is displayed. To execute, tap [Yes]
to hear an electronic sound and finish setting. To
cancel, select [No] and tap it.
-"Writing succeeded" is displayed on the screen, and then ini-
tialize a setting data is written to the servo.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed usually. Check the T10PX and
servo connection or receiver and servo connection to servo
and repeat [Reset]. (Check receiver power supply etc.)
-"Reading succeeded" is displayed on the screen, and the ser-
vo's ID cord and currently set contents are read.
- If "Failed" is displayed on the screen, communication with the
servo is not being performed normally.
- Check the T10PX and servo connection or receiver and ser-
vo connection to servo and repeat [Read].
power supply etc.)
(Check receiver