FUTABA T10PX Full Manual page 195

BEC voltage
MC940,960CR/:6.0V/7.4V
Same as Link software BEC Volt.
The receiver BEC voltage can be selected from 6.0V and 7.4V. Match
the voltage to the rating of the servo connected to the same receiver.
This BEC voltage cannot output a voltage higher than the input voltage.
For instance, if a 6.0V receiver and servo are used with a power supply
voltage of 7.4V or more, set the BEC voltage to 6.0V, and when a high
voltage receiver and servo are used, set the BEC voltage to 7.4V.
Turbo mode
MC940,960CR/: Turbo0/Turbo1/Turbo2
Same as Link software Turbo Mode.
This function sets the turbo mode. More power can be displayed by using the turbo mode.
Depending on the setting, the motor and ESC may be damaged, so make this setting care-
fully.
(Note) When "Lead angle use" is INH, the lead angle setting will not operate even if set to
"Turbo1" or "Turbo2". (Turbo mode disabled, Turbo0=Off)
-Turbo0 mode: (No Lead Angle mode) Lead angle - No
When used in races in which the lead angle setting function is inhibited by
ESC, set to this mode. The lead angle function is disabled the same as if
"Lead angle use" was turned off.
If the "Lead angle" function is disabled by the above method, the
MC940,960CR confirms that the "Lead angle" function is not working by
blinking the blue LED with a cycle of 0.1 seconds on and 0.9 seconds off at
the neutral point. Indicate.
-Turbo1 turbo mode: (Lead Angle mode) Lead angle – Yes
The output can be increased by setting a lead angle.
Depending on the set value, the motor may be damaged so increase the lead
angle value in steps from a small amount while observing the conditions.
Turn on "Lead angle use" and adjust the lead angle by "Lead angle" and
point A, B, C, D, E (A, B, C, D, E Lead angle) value.
-Turbo2 power mode: (Power Mode) Lead angle – Yes
Displays still more power than a turbo.
However, since even a motor applies a large load on the ESC, make the lead angle larger in steps from
a small value while observing the conditions.
Turn on "Lead angle use" and adjust the lead angle by "Lead angle" and point A, B, C, D, E (A, B, C, D,
E Lead angle) value.
Power point A
MC940,960CR/:6.0V/7.4V
Same as Link software Power Point A.
When the turbo mode is power 2 (Power mode), and the lead angle is large, movement may
become stiff when entering the course, etc. In this case, make operation smooth by lowering
the set speed at power point A.
This function is not performed in modes other than Turbo 2.
MC940,960CR