FUTABA T10PX Full Manual page 155

2
(Channel setup)
The channel list screen used for the gain steering channel is displayed. Tap the auxiliary
channel that connected the gain steering channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (Linkage menu).
3
(Flap rate check and adjustment)
Tap the value button of the "Flap", value input buttons appear
on the screen and use the [+] and [-] buttons to adjust the
flaps rate amount.
4
(Rudder to Flap mixing amount adjustment)
Tap the value button of the "Rudder to Flap", Value input but-
tons appear on the screen and use the [+] and [-] buttons to
adjust the mixing amount.
"+": Operate in same direction as steering
"-": Operate in opposite direction of steering
5
(Flap to Rudder mixing amount adjustment)
Tap the value button of the "Flap to Rudder", Value input but-
tons appear on the screen and use the [+] and [-] buttons to
adjust the mixing amount.
"+": Operate in same direction as auxiliary channel
"-": Operate in opposite direction of auxiliary channel
6
When finished, return to the Mixing menu screen by pressing the HOME button twice.
Trim/Dial Setting
The mixing rate amount can be controlled with the digital dial or digital trim, using the
WULP GLDO VHOHFW IXQFWLRQ /LQNDJH PHQX
The number of channels
varies depending on the
selected system.
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Mixing amount (Rudder to Flap)
-100~+0~+100
Initial value: +100
Mixing amount (Flap to Rudder)
-100~+0~+100
Initial value: -100