Introduction - Quectel SG560D Series Hardware Design

1

Introduction

This document defines the SG560D series module and describes its air interfaces and hardware
interfaces which are connected to your applications.
With this document, you can quickly understand module interface specifications, electrical and
mechanical details, as well as other related information of the module. The document, coupled with
application notes and user guides, makes it easy to design and set up mobile applications with the
module.
Modifications:
Any changes or modifications not expressly approved by Quectel or the party responsible for
compliance could void the user's authority to operate the equipment and invalidate the regulatory
approval.
Host manufacturer must follow KDB Publication 996369 D04 Modulen Integration Guide.
Host manufacturer is responsible for regression tests to show compliance to the applicable standards
due to the following actions:
1.any modification done to the module.
2.Integration of the module into a host device
Host product manufacturer is responsible for compliance to any other FCC rules that apply to the host
not covered by the modular transmitter grant of certification.
Final host product is required to show compliance to Part 15 Subpart B with the modular transmitter
installed
Product Marketing Name：Quectel SG560D-WF
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based
timeaveraging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion
Requirements of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user's
body and must not transmit simultaneously with any other antenna or transmitter.
3. A label with the following statements must be attached to the host end product:
This device contains FCC ID: XMR2023SG560DWF
FCC/ISED Regulations restrict operation of this device to Indoor Use Only
4. Antenna Requirements:
SG560D_Series_Hardware_Design
Smart Module Series
12 / 133