Introduction - Quectel EG060K Series Hardware Design

LTE-A Module Series
1

Introduction

This document defines EG060K and EG120K series modules and describes their air and hardware
interfaces which are connected to your applications.
With this document, you can quickly understand module interface, electrical and mechanical
specifications, as well as other related information of the module. The document, coupled with
application notes and user guides, makes it easy to design and set up mobile applications with the
module.
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The
antenna installation and operating configurations of this transmitter, including any applicable source-
based timeaveraging duty factor, antenna gain, and cable loss must satisfy MPE categorical Exclusion
Requirements of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user's
body and must not transmit simultaneously with any other antenna or transmitter.
3. A label with the following statements must be attached to the host end product: This device contains
EG120K-NA FCC ID: XMR2022EG120KNA
EG060K-NA FCC ID: XMR2022EG060KNA
4. This module must not transmit simultaneously with any other antenna or transmitter
5. The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other operating
configurations, including portable configurations with respect to 2.1093 and different antenna
configurations.
For this device, OEM integrators must be provided with labeling instructions of finished products.
Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
A certified modular has the option to use a permanently affixed label, or an electronic label. For a
permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2
Certification (labeling requirements) above). The OEM manual must provide clear instructions explaining
to the OEM the labeling requirements, options and OEM user manual instructions that are required (see
next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module's FCC ID is not visible
EG060K &EG120K _Series_Hardware_Design 11 /
103