Quectel SG560D Series Hardware Design page 56

USB0_SS2_TX_P
USB0_SS2_TX_M
USB0_SS2_RX_P
USB0_SS2_RX_M
USB_VCONN
USB0_CC1
USB0_CC2
USB_PHY_PS
SS_DIR_OUT
USB_OPTION
USB0_DP_AUX_P
USB0_DP_AUX_M
SG560D_Series_Hardware_Design
348 AO
345 AO
352 AI
349 AI
375 PI
339 AI
342 AI
338 DI
341 DO
337 AI
620 AIO
619 AIO
USB 3.1 channel 2 SuperSpeed
transmit (+)
USB 3.1 channel 2 SuperSpeed
transmit (-)
USB 3.1 channel 2 SuperSpeed
receive (+)
USB 3.1 channel 2 SuperSpeed
receive (-)
Power supply for E-Mark cables
USB Type-C detect 1
USB Type-C detect 2
CC status detection
CC status output
Initial configuration for mode
selection when powering up USB
Displayport auxiliary channel (+)
Displayport auxiliary channel (-)
Smart Module Series
Externally
connected to
VPH_PWR or
dedicated boost
converter.
When Micro-USB
mode is used, this
pin can be used as
USB_ID.
When USB Type-C
mode is used,
connect it to
SS_DIR_OUT.
When Micro-USB
mode is used, this
pin needs to be
connected to
ground through a
1 kΩ resistor.
When USB Type-C
mode is used, keep
it unconnected.
When Micro-USB
mode is used, it
needs to be
connected to
ground.
55 / 134