Table of Contents
Advertisement
Figure 4–1: Host IP Settings
Close the control panel and reboot the host computer after making an IP address
change to be sure the change takes effect.
Either reconnect to the installed network
or continue with this direct connection to access the eAMP1-S8-DA Web
GUI.
Network Connection
When connected to a network, the eAMP1-S8-DA address will need to be changed
to another address in order to be compatible with the address assignments for that
particular network. Immediately after the host setup is complete, change the
eAMP1-S8-DA's address. Make the corresponding address, mask and gateway
changes in the eAMP1-S8-DA Network Setup page. Refer to the Network Setup
section which follows.
Otherwise set the eAMP1-S8-DA to DHCP address mode by checking the box for
'Use DHCP?' in Network Setup and have your IT administrator assign rights and
settings for operation on the network. Allow enough time for your network's DHCP
server to recognize a new network device and assign an address after booting.
The eAMP1-S8-DA uses link local addressing for its internal network, so no
accommodation for this need be made in the network.
Page 44
eAMP1-S8-DA
Advertisement
Table of Contents
