Channel Meters And Touch Operations - Wohler eAMP1-S8-DA User Manual

Channel Meters and Touch Operations

The audio mixer terminology of "solo" is used in this manual when referring to
muting all but a specific audio channel or pair.
Audio meters are displayed on touchscreen LCD display(s) in up to 8 channel pairs,
as shown in Figure 2-6.
1. Channel Source and Channel Number: Above the level meters are the
channel identifiers. They indicate the channel input source and
consecutive channel numbers in the selected source.
2. Speaker Assignment: The speaker assignment for each channel is
shown as follows:
An arrow pointing to the left indicated that this is a left channel and
will be monitored in the left speaker.
An arrow pointing to the right indicated that this is a right channel and
will be monitored in the right speaker.
A square indicates that this is a center channel and will be monitored
in both speakers.
3. Source: This indicates the input source of the displayed channel.
4. Loudness Cluster Marker: Loudness Measurement is available if the
OPTe Package is purchased. This orange bracket marks which cluster is
currently being measured for Loudness.
5. Loudness Reading: Loudness Measurement is available if the OPTe
Package is purchased. This control displays the Loudness of the selected
Cluster. It can also be touched to change which Cluster is being
measured. To do this, touch the green Loudness Reading control. It will
temporarily turn orange. You may then touch the meters in any other
cluster. The Loudness Cluster Marker will then move to that cluster and
its measurement will begin and be displayed. You may then touch the
control again to return it to its green color, restoring normal touch
eAMP1-S8-DA
Figure 2-6: Audio Level Meter Screen
Page 14