Typical Questions Regarding Global Output Routing; What Signal Outputs Can Be Controlled Using The Global Output Routing Feature; How Do I Route Whatever Is Being Monitored To The Xlr And Aes Outputs - Wohler eAMP1-S8-DA User Manual

by solos and mutes. The Speaker/Headphone output is always affected by
solos and mutes. Note also, that all outputs in Speaker Mix mode also are
affected by solos and mutes.
3. Mute on Headphone Insertion: This option controls whether the outputs
should be muted upon a headphone insertion. This setting can be adjusted
even for outputs whether they are in Speaker Mix or Free Mix modes.
4. Volume Control: This setting determines whether each output pair is
adjusted by the Volume Control knob. Speaker/Headphone outputs are
always affected by the volume control knob, as are any outputs that are in
Speaker Mix mode.
Typical Questions Regarding Global Output
Routing
The questions and thoughts in this section are commonly asked by people when
setting up the licensed OPTe Output Routing capability.
What signal outputs can be controlled using the Global Output
Routing feature?
All the outputs on the eAMP1-S8-DA can be controlled using the Global Output
Routing feature. This includes – Internal Speakers, Analog XLR outputs, all 4 pairs
of AES outputs on HD-15, and the 4 pairs of Analog outputs on DB-25.
How do I route whatever is being monitored to the XLR and AES
outputs?
Using Global Output Routing, you may route any signals to the XLR & AES
outputs. You may route signals to the XLR outputs using the Analog/XLR
checkboxes and route signals to the AES outputs by using the AES/Pair 1 to Pair
4 checkboxes.
As shown in the above example, signals appearing on Audio Meter channels 1
through 8 are routed to AES Pair 1 and signals from Audio Meter channels 9 to 16
are routed to the Analog XLR outputs.
eAMP1-S8-DA
Page 63