Wohler eAMP1-S8-DA User Manual page 32

Figure 2-27: Network Configuration: Setting Change
2. Touch the digits to be entered and then touch the Enter button. The Clear
button may be touched to erase any mistyped digits.
3. Now repeat steps 1 and 2 until you have replaced all of the necessary digits.
4. To save the newly entered address, touch the Enter button. Touch the
Cancel button to return to the previous screen without saving any changes.
Important:
There is no confirmation for Save, so make sure you want to perform
this action before taking it. The system does not need to reboot before
it is once again ready for operation.
To change from a static (fixed) to a dynamic (DHCP) network address, touch the
DHCP button. The screen will change, as shown in Figure 2-28. To change back to
a static (fixed) network address, touch the DHCP button again. The colors of the
buttons will return to the ones depicted in Figure 2-26.
1. To complete the network addressing scheme change, touch the Save button.
This will save the changes you selected.
eAMP1-S8-DA
Figure 2-28: Network Settings: DHCP
Page 32